Bits and Pieces for Carrera 64065: What You Get and How to Use Them

By Carrera； Der Spezialist | Published: 2026-10-26

Category: How-to Guides

Learn exactly what the 'bits and pieces for 64065' set includes and how to use these Carrera spare parts to repair your GO!!! race track.

Quick Answer

The Carrera 'bits and pieces for 64065' set contains small spare parts for the GO!!! race track system. This guide explains what each piece is and how to install them to fix common track issues.

Why You Might Need These Bits

Over time, the small plastic clips, rail connectors, and track pins on a Carrera GO!!! track can break or go missing. The bits and pieces set is designed to replace those exact components, saving you from buying a whole new track section.

A common frustration is losing the tiny bridge clips that hold track sections together. Without them, the track can separate during a race. This set provides a handful of those clips, along with a few other small but essential parts.

What Is Not in the Set

This is a spare parts set, not a track expansion. It does not include any track pieces, cars, controllers, or power adapters. If you need a new straight or curve section, look for a separate Carrera GO!!! track pack.

How to Use the Bits and Pieces for Carrera 64065

1. Identify the Parts: Open the set and lay out the pieces. Typically you will find small black bridge clips, rail connectors, and plastic track pins. Compare them to the broken or missing parts on your track. Common mistake: Trying to force a part into the wrong slot. If it does not fit easily, you have the wrong piece.
2. Replace a Broken Bridge Clip: Slide the new bridge clip into the groove on the underside of the track section where the two pieces join. Push it until it clicks into place. The clip should sit flush with the track surface. Checkpoint: Ensure the clip is fully seated. A loose clip will cause the track to separate during play.
3. Install Rail Connectors: If the metal rails on your track have a gap or poor connection, insert a rail connector into the slot at the end of one rail, then press the adjoining track piece onto it. The connector bridges the electrical circuit. Common mistake: Using a rail connector on a curved section that already has a built-in connector. Only add one where the rails are separate.
4. Secure Track Pins: Track pins are used to lock track sections together at the corners. Insert the pin through the hole in the side of the track tab, then twist to lock. This prevents the track from sliding apart. Checkpoint: Do not overtighten. The pin should hold the sections snugly but still allow easy disassembly.
5. Test Your Repairs: After replacing all damaged or missing parts, assemble a short test track. Run a car slowly over each repaired joint to check for smooth power delivery and secure connections. If the car stutters or stops, recheck the rail connectors and bridge clips. A poor electrical connection is the most common cause.

Product Details

bits and pieces for 64065: This Carrera item is listed as bits and pieces for 64065, offered under the Carrera brand from Carrera; Der Spezialist. It is categorized with spare parts and GO!!! race track tags. This confirms the set is designed specifically for the Carrera GO!!! system, so you can be confident the parts will fit your track.
bits and pieces for 64065