2.4 GHz Small Controller Style Turnator: Setup and Pairing

By Carrera； Der Spezialist | Published: 2026-10-26

Category: How-to Guides

Learn how to set up and pair your Carrera 2.4 GHz Small Controller (CZ) Style Turnator #160023 with step-by-step instructions, common mistakes, and practical tips.

Quick Answer

To set up your Carrera 2.4 GHz Small Controller (CZ) Style Turnator #160023, insert fresh batteries, power on the vehicle, then press the pairing button on both units within a few seconds. Follow the step-by-step process below to avoid common pairing mistakes.

Why 2.4 GHz Makes Pairing Easier

The 2.4 GHz band used by this Carrera controller is less crowded than older frequencies, which means fewer interference problems and more reliable control. Because it uses a digital binding process, you don't need to worry about matching crystals or tuning antennas. However, the pairing procedure must be done correctly each time you use a new receiver or after replacing the controller's batteries.

Common Pairing Pitfalls to Avoid

One frequent mistake is turning on the vehicle before the controller, which can cause the receiver to enter a search mode that fails to bind. Another is pressing the pairing button too quickly or too slowly; timing matters. Also, low batteries on either the controller or the vehicle can prevent a successful link, so always start with fresh cells.

Step-by-Step Setup and Pairing

Insert fresh batteries: Open the battery compartment on the back of the controller and insert fresh AA batteries, matching the polarity markings. Close the compartment securely. Check that the battery contacts are clean and that the batteries are not rechargeable unless specified.
Power on the controller: Slide the power switch to ON. The LED indicator should light up. If it doesn't, check battery installation. If the LED blinks rapidly, it may indicate low battery – replace them before continuing.
Power on the vehicle: Turn on your Carrera RC vehicle using its own power switch. Wait for the vehicle's LED to start blinking, indicating it's in pairing mode. If the vehicle's LED stays solid, it may already be paired – skip to step 5 to test.
Press the pairing button: On the controller, press and hold the pairing button (often located near the wheel or on the back) for about 2 seconds. The controller's LED should flash. Within 3 seconds, press the vehicle's pairing button (if available) or simply wait for the vehicle's LED to turn solid. If the vehicle doesn't link within 10 seconds, turn both units off and start again from step 2.
Test the connection: Move the steering wheel and trigger to confirm the vehicle responds correctly. If the vehicle doesn't respond, repeat the pairing process. If problems persist, check for interference from other 2.4 GHz devices and move to an open area.

Product Facts

2.4 GHz Small Controller (CZ) Style Turnator #160023: This Carrera 2.4 GHz Small Controller (CZ) Style Turnator, item number 160023, is part of the controller and antenna range for RC use. It's designed specifically for Carrera RC vehicles, so pairing is straightforward when you follow the manufacturer's sequence.
2.4 GHz Small Controller (CZ) Style <tc>Turnator</tc> #160023