Red Hunter Rear Bumper (142007): Replacement and Fit Steps

By Carrera； Der Spezialist | Published: 2026-11-04

Category: Recensioni prodotti

A practical, step-by-step guide to replacing the rear bumper on your Carrera Red Hunter using part 142007, with checkpoints to avoid common fitting mistakes.

Quick answer

Replace the rear bumper on your Carrera Red Hunter with part 142007 by removing the old bumper, checking the mounting points, and securing the new one without overtightening. Work slowly and test the fit before fully tightening any screws.

Why the rear bumper matters more than you think

The rear bumper on the Red Hunter absorbs impacts from reversing, curb scrapes, and rear-end collisions. A cracked or missing bumper leaves the chassis and body exposed, so replacing it promptly protects more expensive components. The 142007 bumper is a single replacement component, so you only need to swap the damaged part rather than hunt for a full rear assembly.

When to replace instead of repair

If the bumper is cracked, warped, or missing a mounting tab, replacement is usually the safer choice. Small scuffs that do not affect mounting or alignment can often be left alone. Because the 142007 is a direct replacement for the Red Hunter, it is the correct spare when the original bumper is beyond simple cosmetic wear. If you are unsure whether your model is the Red Hunter, check the chassis or body for the model name before ordering.

Step-by-step rear bumper replacement

Remove the old bumper: Unscrew or unclip the damaged rear bumper from the chassis. Keep the screws and any small clips in a container so they do not get lost. Checkpoint: before discarding the old bumper, note how it sits against the body—this helps you align the new one.
Clean the mounting area: Wipe away dirt and debris from the chassis mounting points with a dry cloth or soft brush. A clean surface helps the new bumper seat properly. Common mistake: skipping this step can leave grit under the bumper, causing it to sit unevenly.
Test-fit the new 142007 bumper: Place the new bumper onto the mounting points without tightening any screws. Check that the holes line up and that the bumper sits flush against the body. Checkpoint: if the bumper does not sit flat, do not force it—recheck that you have the correct part and that no debris is trapped.
Secure the bumper: Install the screws or clips finger-tight first, then tighten them in a cross pattern (top-left, bottom-right, etc.) to avoid warping the bumper. Common mistake: overtightening can crack the plastic or strip the mounting holes—stop when the bumper feels snug.
Check movement and clearance: Gently wiggle the bumper to confirm it is secure. Roll the car backward and forward to ensure the bumper does not rub against the tires or ground. Checkpoint: a properly fitted bumper should have no side-to-side play and should not contact the wheels during suspension travel.

Product facts

1 rear bumper for Red Hunter (142007): This is a single rear bumper replacement for the Carrera Red Hunter, part number 142007. You get exactly the part you need to restore the rear of your Red Hunter without buying a whole rear assembly.
1 rear bumper for Red Hunter (142007)