Parts for 41320 and 61260: Fit Check and Replacement Steps

By Carrera； Der Spezialist | Published: 2026-11-04

Category: How-to Guides

Use the set number and the broken part to confirm the right Carrera GO!!! spare before ordering. Then follow a short replace-and-test routine to get the track running again.

Quick answer

Match the spare to both your set number (41320 or 61260) and the exact part that failed, then replace only that part and test the track before storing it. The Carrera spare-parts item for 41320 and 61260 is the correct starting point when your set is one of those two references.

Why the set number matters more than the part photo

Carrera GO!!! sets share a scale and track style, but the spare-parts listing is tied to specific set references. A part that looks similar in a photo may belong to a different set, so the set number on the box or manual is the first thing to check. The supplied catalog entry for this spare lists 41320 and 61260 as its compatible set references, which makes it a narrow fit rather than a universal GO!!! part.

If your set number is not on that list, stop and identify the correct reference before ordering. The catalog does not list every GO!!! set, so an absent set number is a limitation of the listing, not proof that the part fits.

When replacing is the right call, and when it is not

Replace the part when the failure is visible and local: a cracked piece, a missing connector, or a section that no longer joins cleanly. If the whole track still runs and only one joint is loose, check the connection first, because a poor fit can imitate a broken part.

Do not order a spare to fix a car that will not move. Power, pick-up shoes, and controller issues are separate from track hardware, and the supplied catalog facts for this item describe a track spare only. Diagnose the car separately before spending on track parts.

Replace and test the part in order

Write down the set number: Find the set reference on the box, manual, or track packaging and confirm it reads 41320 or 61260. Common mistake: ordering from a photo of the broken piece without checking the set number. If the set number is different, do not order this spare until you confirm the correct reference.
Identify the exact failed part: Compare the broken piece with the spare-parts item and confirm it is the same part, not just a similar-looking one. Common checkpoint: if you cannot tell which part failed, test the track section by section before ordering.
Power down and clear the track: Switch off the power and disconnect the controller before touching the track. Remove only the section that holds the failed part. Common mistake: pulling connected sections apart and cracking a neighbouring joint.
Remove the old part: Release the failed part from its section without forcing it. Keep any small connectors or pins with the section so they can be reused if the new part needs them. Common mistake: losing a connector during removal and then blaming the new part for a loose fit.
Fit the replacement and check alignment: Seat the new part fully, then join the section back to the track and check that the surface is level and the joint is tight. Common checkpoint: a part that sits proud or leaves a gap is not fully seated, so reseat it before powering up.
Test at low speed, then store correctly: Run a car slowly through the repaired section and watch for hesitation or derailment. If it runs cleanly, store the track unjoined and flat so the new part is not left under stress. Common mistake: packing the track tightly joined, which can loosen the replacement joint again. If the car still hesitates at the repaired joint, recheck seating before ordering another part.

Product facts

parts for 41320, 61260: Carrera spare-parts item listed for set references 41320 and 61260 in the GO!!! range. Check your set number against those two references before ordering, because this spare is not described as a universal GO!!! fit.
parts for 41320, 61260