Bits and Pieces for Carrera 61173 and 41337: Spare Part Guide
By Carrera； Der Spezialist | Published: 2026-10-31
Category: How-to Guides
Learn how to check, sort, and install the Carrera bits and pieces kit for items 61173 and 41337, with a practical step-by-step process and fit checkpoints.
Quick answer
Use the Carrera bits and pieces kit for items 61173 and 41337 only after confirming both item numbers on your GO!!! setup, then sort the small parts by location before replacing anything. Install one part at a time and test the track section after each change.
Why the item numbers matter more than the kit photo
Carrera GO!!! spare parts are easy to mix up because many small pieces look similar across sets. The listing for this kit names items 61173 and 41337 specifically, so those numbers are your first fit check. If your track section or accessory does not carry either number, this kit is not the right starting point even if a part looks close.
The catalog does not list the individual contents of this kit or the exact position of each piece. Treat the kit as a set of replacement bits for the referenced items, not as a universal upgrade, and use the original part as your visual reference during installation.
When this kit is the wrong choice
If your problem is a cracked track section rather than a small fitting or connecting piece, a bits-and-pieces kit will not solve it. The same applies when the damaged part belongs to a different Carrera item number. In those cases, identify the correct spare part number first instead of forcing a near-fit.
This kit is also a poor fit if you have lost the original part and have no reference for its position. In that situation, check the exploded view or parts list for items 61173 and 41337 before ordering, because the listing does not include a position map.
Step-by-step: installing the bits and pieces kit
- Confirm the item numbers: Find the item number on the track section or accessory you are repairing and check that it reads 61173 or 41337. Common mistake: matching by appearance alone, which often leads to a part that seats loosely or not at all. Photograph the item number before you start so you can reorder the right kit later.
- Unplug the power and clear the track: Disconnect the power supply and remove the affected section from the layout before handling small parts. Common mistake: working on a live or connected track, where a dropped piece can bridge contacts.
- Lay out the kit and compare with the original: Empty the kit onto a light-colored tray and match each piece to the removed original by shape and size. Because the listing does not itemize contents, set aside any piece you cannot match and do not force it into place. Keep unmatched pieces separate and identify them before reassembly.
- Replace one part at a time: Fit the first replacement, reseat the section, and run a slow test lap before moving to the next part. Common mistake: replacing several pieces at once, which makes it hard to tell which part caused a new misalignment. If a part feels tight, stop and recheck its orientation rather than pressing harder.
- Test the full section under power: Reconnect power and run a car through the repaired section at low speed, then at normal speed. Listen for rattles or scraping that suggest a piece is not fully seated. A part that works at low speed but rattles at full speed usually needs reseating, not replacement.
Product facts
- bits and pieces for 61173, 41337: This Carrera kit is listed as bits and pieces intended for use with items 61173 and 41337, under SKU code 20088243. The stated item numbers are your compatibility check, so confirm them on your GO!!! setup before opening the kit.
bits and pieces for 61173, 41337
